Detailed Selling Lead Description

Operation Procedures :
1. Before coming into use, insert the power cord and the array into the corresponding jacks in chassis, place the array into a basin filled with water, and then turn the power on and press the ON / OFF button.
2. The Time and the Work Pressure will show the accumulative treatment time used. The Work pressure will indicate the no. of hours and the Time will indicate the no. of minutes used. When the total amount of time used is up to 60 min, there will be an increase in one hour shown in the Work pressure panel. Eg. if the total accumulative time used is one hour twenty minutes, the Work pressure panel and the Time panel will display the no. 002 and 20 respectively.
3. When the accumulative time showing step is completed, the whole device will back to the “ Ready ” state of operation with
i. The Time shows at 30 min., the predetermined treatment time. 
ii. The Mode shows at 1, that is mode no.1, the pre-determined treatment mode. There are 4 modes for selection with mode no. 4 the strongest and no. 1 is the weakest among the 4 modes.
iii. The Work pressure shows the word “ OFF ” , a ready state
iv. The Work electricity shows at “ 0.00 ”, a ready state.

4. We could now start detoxification by pressing the “Start / Stop” button. 
i. The Work pressure will change from “OFF” to “ 12.0 ” which means the device is under 12 voltage (V).
ii. The Work electricity will change fluctuate in between 0.00 and 5.00 ampere (A). And for BEST detoxification to take place, the best ampere used should be controlled in between 3.00 and 4.20 A . It could be done by adding suitable amount of “Salt Water” to make the ampere reach the desirable reading, 3.00 ～ 4.20A. 

6. The device will prompt sound when the you add too much salt water to make the work electricity jump to 4.50 instantly, and the whole device will even “STOP” function when it reaches 5.00A as protection with the Work pressure changed to “OFF” mode. At this time, we have to pour